Festool TKS 80 Sliding Table ST TKS80
107048
Festool TKS 80 Sliding Table ST TKS80
107048
Key Features
- 4 bearing rollers for ultra-smooth travel
- Enable cross-cuts of up to 920mm
- Choice of 2 positions for different workpieces
- Adjustable stops front and rear
- Installed and fully adjusted in minutes
- View full description
Customers Also Viewed
Recommended Accessories
Show more
Show less
The table runs along a robust aluminium profile on four bearing rollers giving ultra-smooth travel. Attached to the left hand side of the TKS 80 saw table, it enables cross cutting up to 920mm in width. The profile can be attached in a choice of two positions depending on the type and size of the workpiece. Adjustable stops front and rear can be used to limit the length of travel. Installing the sliding table is straightforward. Installation and all set-up adjustments can be done in just a few minutes.